![]() |
|
||||||||
| |||||||||
| Notices |
![]() |
|
|
LinkBack | Thread Tools |
|
||||
|
Nov 27th, 06, 08:41 PM
Ryder is quite particular about their wash vendors, Penske too and recovery is required for them. I had to fill out about 20 pages of documents, have tons of insurance, and they also want a special pollution liability policy. The paper work was a pain but once you are an approved vendor you will have some protection because it is a long and confusing process filling out the forms. Your best bet is to find out who the areas enviromental guy is for them and see if you can submit a bid. Good luck, let me know if you need help with the paperwork.
Envirospec North/Mobi Clean Inc. www.envirospecnorth.com Your source for pressure washer parts, pressure washer supplies and pressure washer technical support. 877-351-1238 |
|
||||
|
Nov 29th, 06, 09:14 AM
If you have an in use it, they can be a good accout to have. Just be sure you are setup for recollecting.
Envirospec North/Mobi Clean Inc. www.envirospecnorth.com Your source for pressure washer parts, pressure washer supplies and pressure washer technical support. 877-351-1238 |
|
||||
|
Nov 30th, 06, 12:08 PM
WHAT CAN IF RECOLLECTING ARE THEY LOOKING FOR, WHAT KIND OF INFO ARE THEY LOOKING FOR IN THE 20 PAGE PAPER WORK IF YOU R COULD EMAIL ALL THE INFO THANK YOU MY E MAIL ADDRESS IS mcbrda@comcast.net thank you again , I WOULD LIKE TO GET THIS ACCOUNT DOESN'T PAY MUCH FOR ONE TRUCK BUT FOR THE WHOLE FLEET GOOD MONEY THEY HAVE LIKE 100 TRUCKS IN ARE AREA , THE GUY WHO DOSE THEM NOW IS SLACKING ,
|
|
||||
|
Nov 30th, 06, 09:08 PM
The recollection will vary based on area bur for ryder they want the water sucked up and hauled off and treated or disposed of properly. They require paperwork for this as well as what is done with the solids, dirt, gravel, wood parts etc... If you have a shop you can get a letter from the POTW or if it is septic from the Hauler. Also check with your state wht the requirements are for hauling the waste water. For example in Illinois you need o be a lic.waste hauler where in Wis. it is not regulated. Your best bet is to call your local DNR office and Public Owned Treatment Works (POTW) and they can steer you in the right direction. In the mean time I will see what I can come up with and get back to you, It may take a few days.
Envirospec North/Mobi Clean Inc. www.envirospecnorth.com Your source for pressure washer parts, pressure washer supplies and pressure washer technical support. 877-351-1238 |
|
||||
|
Dec 1st, 06, 03:57 PM
I want every thing needed to get the contract and build up from there is that puting it better ,it like everything else you can go out and get it all, but right now this is the only company that requrie it. I just want a basic unit to be compliant with ryder rite now ,
|
|
||||
|
Dec 1st, 06, 04:04 PM
Quote:
|
|
||||
|
Dec 1st, 06, 06:36 PM
Buy A TRUCH WASH MAT IF IT IS A POSSIBILITY FOR YOU..
http://www.ds-sewing.com/tough/toughtarps1.htm NO MOLD TOO OLD! EMAIL. PRESSURECLEANINGGUY@YAHOO.COM WEST PALM BEACH FLORIDA 561/714-3211 |
|
||||
|
Dec 1st, 06, 07:38 PM
i am unsure if they allow you to drive there trucks good idea. i just want to know what kind of unit i need vacboom, or the ground is flat asphlat . they cost around 2300 which is not bad , just need some help to fingure all this out , this work could be a even for me to go complete full time, w / the house we already wash and new customer we are getting
|
![]() |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|