![]() |
|
||||||||
| |||||||||
| Notices |
![]() |
|
|
LinkBack | Thread Tools |
|
|
|
||||
|
Mar 31st, 08, 05:32 PM
I replaced the air filter today and it fired up and ran for a little while until it got hot and skipped a couple of times and cut off. I pulled spark plug out and checked to see if getting fire and nothing. Apparently it is losing fire after it warms up. coil?
919 818 8038 cpcleaning62@yahoo.com |
|
||||
|
Apr 1st, 08, 01:29 PM
14 years? Treat yourself to a new one.
SETTING THE NEW STANDARD IN KEC ROGER MEDBERY 770-474-5510 Restaurant Hood Cleaning |
|
||||
|
Apr 1st, 08, 08:45 PM
Envirospec North/Mobi Clean Inc. www.envirospecnorth.com Your source for pressure washer parts, pressure washer supplies and pressure washer technical support. 877-351-1238 |
|
||||
|
Apr 6th, 08, 09:13 AM
I ordered the coil and replaced it,still no crank,I unplugged the green wire coming from lower portion of the block and it fired right up.I guess this is the low oil sensor.apparently bad, plugged back together and it kills the engine.The coil was cheap enough to try. I think i'll just keep a check on the oil and the heck with the sensor.
919 818 8038 cpcleaning62@yahoo.com |
|
||||
|
Apr 6th, 08, 01:05 PM
Could be such, or maybe there is some shorting issue...
Some engines that move around on machinery will sometime show a low oil situation by cutting out or partial stall during use before they go totally out in starting situations. I'll be darned if I can regonize where or how it works on my Onan though..never noticed a wire. If that was what the wire is for in your situation chalk it up to luck that ya found out problem without taking to shop. You should be able to plug it back in and all be fine once ya filled with oil. I wouldn't assume it is broke especially after it did it's job. Thank it by keeping it plugged in.. Sacramento, CA "Wood Refinishing-Pressure Washing- Concrete & Vinyl Floor Care- ~~~> done right by a leftist coast" mmienterprises@hotmail.com |
![]() |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|